New Robots

[Craig_Anto3]

I have Australian nationality so I could wave the flag for the land down under but i wont

[Team Orr]

i could represent the scot's

[terminaldamage]

I was gonna say, we need to get some Scots representation in there
All I need is to get another servo drive motor and my little Chaos 2 pullback will be fully functioning, although probably overweight and susceptible to a trashing

[haz]

arn't we all

[joey_picus]

If we're being tenuous I was born near Dumbarton, does that count?

[Panzerbot]

Here a now video of my Ant whit the full Power of the LEDs:
http://www.youtube.com/watch?v=A1e0tfDmF-M

[Paddonjon]

haha.. wheel came off

those LED's look amazing ! 8)

[Panzerbot]

When you see a few second in this 4 LEDs your eyes hurt xD
I hadn?t glue the wheel, but befor MMM I will make it.

[Paddonjon]

I have just Finished the Prototype of PhANTom its probebly not worthy enough to even be posted on here but.... lol


Its a bit over weight at the moment but when i get Peters receiver/speed controler that hes made for me + lipo batteries it should hopfully be ok
I will replace the red tape with plastic armor on the real one and rivit the wings to the body rather than dodgy keyrings also i am sorting out a way to keep it ballanced especialy for when the lifting arms are being used... i will probebly put like little platic caster like things on .. unfortunatly i cant demonstrate the weapons working in the video because its only got a 2 channel transmitter.. but i asure you they work

Does it look ok for an Antweight or do you think it will be turned into scrap in seconds ? lol

Here is a video of it working and how it unfolds

Video >> http://www.youtube.com/watch?v=57CEkk-_2fA

[joey_picus]

For a first attempt it's not at all bad, you should have seen my first few robots I like the look of it a lot, the wings do look quite threatening when it spins.