I finally got round to starting work on my new antweight, twister.
I'm going to keep the weapon a secret at the moment, but I assure you it will be good!
I got a bit bored today, so I decide to go into the workshop and see what needs doing.
I got a Baby-Orangutan, as inspired by Jim, as I was in need of a compact and light ESC capable of running 4 motors
I saw the baby-Orangutan, so I wired it up and programmed it, and just now a few tests.
here are the pics and results of the test...
the size of it compared to my finger
Twister
Moderators: BeligerAnt, petec, administrator
-
- Posts: 96
- Joined: Sat Oct 23, 2010 10:14 am
Twister
Ben
The creator of... Laser, Evil Pig Sty and Striker
The creator of... Laser, Evil Pig Sty and Striker
-
- Posts: 96
- Joined: Sat Oct 23, 2010 10:14 am
Re: Twister
the vid of it being tested
http://www.youtube.com/watch?v=14LV4k2m ... e=youtu.be
http://www.youtube.com/watch?v=14LV4k2m ... e=youtu.be
Ben
The creator of... Laser, Evil Pig Sty and Striker
The creator of... Laser, Evil Pig Sty and Striker
- earthwormjim
- Posts: 1190
- Joined: Thu Sep 16, 2010 4:57 pm
- Location: Secret Undisclosed Moonbase Location
Re: Twister
Very nice! Good soldering,too.
Please tell me you are going to mount your jet-engine to the top of it!!!!!
I look forward to seeing it.Aiming for the AWS next week???
Please tell me you are going to mount your jet-engine to the top of it!!!!!
I look forward to seeing it.Aiming for the AWS next week???
-
- Posts: 96
- Joined: Sat Oct 23, 2010 10:14 am
Re: Twister
no I defiantly wont be able to make aws next week, I'm aiming for another AWS later this year.
Lol, I could mount it ontop of the jet engine but I have a feeling it would melt it!
The jet engine was made to go on top of a rc car..
Lol, I could mount it ontop of the jet engine but I have a feeling it would melt it!
The jet engine was made to go on top of a rc car..
Ben
The creator of... Laser, Evil Pig Sty and Striker
The creator of... Laser, Evil Pig Sty and Striker
- peterwaller
- Posts: 3213
- Joined: Fri Feb 15, 2002 12:00 am
- Location: Aylesbury Bucks
- Contact:
Re: Twister
You mention in the video that you are going to drive 4 motors the baby Orangutan output chip is rated at 1.2A per channel continuous so you should just about get away with it if you don't stall the motors. As Jim says that is nice soldering and getting down to this level will give you a much better understanding of your robot operation.