would these be ok?
Moderators: BeligerAnt, petec, administrator
the 10a sabertooth is enough to get your robot moving, (both wheels) and if you want a wepon you will need a single chanal speed controler.
For my stuff:
http://bodgeitandhope.blogspot.co.uk/
http://bodgeitandhope.blogspot.co.uk/
-
- Posts: 26
- Joined: Thu Oct 28, 2010 4:54 pm
for the weapon motor you could use a hella big brushless or couple of speed 900's or something. (very fast brushed motor) most people use victor 883 speed controllers for speed 900s. for brushless you'd need a HUGE esc going into the hundreds. you could also possibly use 2 quite large brushless motors but this would require 2 esc's .
-
- Posts: 339
- Joined: Sat Oct 20, 2007 7:20 pm
- Location: worthing/ west Sussex
IS this your fiurst bot? If so id jsut go for a ram bot, spinners take a lot of engineering balancing and maths to get safe. And can get VERY expensive. Didnt spot the new 12A sabertooth till after i posted that, so as th old one i psoted the link to has bene disocntinued id go for th 12 A one, and that will happily drive 2 drill motors on up to about 14.4V for a bit more speed.
Fight or flight ... ?
...suicide
...suicide
-
- Posts: 26
- Joined: Thu Oct 28, 2010 4:54 pm
that sort of thing?
http://www.cornwallmodelboats.co.uk/aca ... _6373.html
and would a 10a esc be ok and how many would i need?
http://www.cornwallmodelboats.co.uk/aca ... _6373.html
and would a 10a esc be ok and how many would i need?
-
- Posts: 26
- Joined: Thu Oct 28, 2010 4:54 pm