Right, got a load of bits and pieces i no longer need and may be of use to someone else so:
12amp brushless esc
20mm brushless outrunner both brand new
Stainless steel disk 70mm dia 28mm id and 2.5mm thick
2 savox micro digital servos sh-0257 without plugs, just wires although plugs could be soldered back on
Mild steel featherweight shell, fully welded. I built it on a day at the robo challenge warehouse but didn't have the time or money to complete it. It was to be a replica of the heavyweight: turbulence.
Several 138mah single cell turnigy lipos As seen in pop at aws33
A single cell lipo charger, charges two at a time from a uk wall socket
2 single cell high discharge lipos 25c
And probably some more when i find it... Post here or send me a pm, i'll try get some pictures up later
Clearout
Moderators: BeligerAnt, petec, administrator
Clearout
RPD International
www.RPDintl.com
www.RPDintl.com
how much for the disc and featherweight shell? also any pictures of it?
For my stuff:
http://bodgeitandhope.blogspot.co.uk/
http://bodgeitandhope.blogspot.co.uk/
60 posted for both? The disk is cnc cut, cost a considerable ammount more than that on it's own. I'll try get some pictures either later tonight or tomorrow
RPD International
www.RPDintl.com
www.RPDintl.com
seems fair. i will give a definate awser when i see some pictures.
For my stuff:
http://bodgeitandhope.blogspot.co.uk/
http://bodgeitandhope.blogspot.co.uk/
The disk is obviously the larger of these two, the smaller one i believe is now in jim's boreworm
This is the shell with the access hatch plate cut to size and the rc ariel although it won't need that with Dsm2 gear.
And this is the motor/esc. The servos were in pop and can be seen in the pop thread under the antweights section.
This is the shell with the access hatch plate cut to size and the rc ariel although it won't need that with Dsm2 gear.
And this is the motor/esc. The servos were in pop and can be seen in the pop thread under the antweights section.
RPD International
www.RPDintl.com
www.RPDintl.com
- earthwormjim
- Posts: 1190
- Joined: Thu Sep 16, 2010 4:57 pm
- Location: Secret Undisclosed Moonbase Location
Just quickly it is 400 long 350 wide and 190 tall was originally for a drill motor and co2 pneumatic setup so there is room to play with inside
RPD International
www.RPDintl.com
www.RPDintl.com
thanks a lot. how much for that on its own?? are you going to the aws in reading?
thanks, harry.
thanks, harry.
For my stuff:
http://bodgeitandhope.blogspot.co.uk/
http://bodgeitandhope.blogspot.co.uk/
Urm on it's own 45 posted? 10 of that will end up as postage. If i get to the aws it will be by train so i don't really have enough hands to bring it down with me
RPD International
www.RPDintl.com
www.RPDintl.com