WANTED

Andrew_Hibberd · Post by **Andrew_Hibberd** » Sat Jul 01, 2006 3:12 pm

How long is the flat face on the motor, just trying to cad it up so i can prototype before i get it.

tom of technology · Post by **tom of technology** » Mon Jul 03, 2006 3:53 pm

i wanted standard size boards but do you know what value resistors to use insted of the pot???

josh · Post by **josh** » Mon Jul 03, 2006 4:37 pm

tom ithink for a standard servo the resistor value u have to use is 2k2 may be wrong tho

Andrew_Hibberd · Post by **Andrew_Hibberd** » Mon Jul 03, 2006 5:09 pm

you are indeed right josh, however it requires soldering close to the board, which could be damaged. Using glue is the simplist method, if you are confident with the soldering iron then have a go. Otherwise you may be able to get some help.

Andrew_Hibberd · Post by **Andrew_Hibberd** » Mon Jul 31, 2006 8:31 am

Half this thread is me

I am looking for some small lipos for a non antweight project, the smallest i have seen are the 40mah cells from indoor flyer. Does anyone else know of any?

peterwaller · Post by **peterwaller** » Mon Jul 31, 2006 12:52 pm

They also do some 20maH cells at indoor flyer. I haven't seen any smaller.

josh · Post by **josh** » Thu Aug 17, 2006 6:10 pm

has anyone got a hitec feather receiver or the newer version of the feather receiver kickin about coz i cant afford 22 pound from smc wen u add postage

Adam Hargreaves · Post by **Adam Hargreaves** » Fri Aug 18, 2006 7:39 pm

I am also suffering cash problems, but would like to find a new tx, 4ch for as cheap as possible. well, a minimum of 4ch, lol

josh · Post by **josh** » Sat Aug 19, 2006 8:17 am

adam i have a futaba skysport 4 that after rrc i dont think ill use it anymore.

Flippt · Post by **Flippt** » Sat Sep 16, 2006 4:30 pm

I'm looking for a C141 servo, as one of mine has blown the pot...

Only looking for the pot, no need for gears or electronics.

RobotWars101

WANTED

great