Couple Ant Questions

[MrEnDo]

Hello,
Ordered all my guts for my bots now.

I can't seem to find a sliding switch rated above 0.5a any recommendations on what you all use?

Also what AWG cable do you use?

Cheers

[peterwaller]

To be honest most of the switches I use are only rated at 0.3 A - 0.5 A.
I work on the assumption that the limiting factor is the switching current and when I switch on or off the motors are not running.
I am not sure I can really justify that but they seem to work OK for me.
You could try these although I haven't :
http://www.ebay.co.uk/itm/On-On-Slide-S ... Sw0j9ZVkmO
I have used 26 SWG for the power and even thinner on for signal wires.

[Shakey]

My switches are officially related to 0.3A but considering I run this guy off them it's fine!

[MrEnDo]

Cheers guys. Got all the parts comming just need to source some wire now.

[Ocracoke]

I recycle of some of the wiring from servo extension leads if I need it, the extra plugs on it forms the basis of my battery and link connectivity (or will I should say - my AW isn't finished yet) - https://hobbyking.com/en_us/15cm-servo- ... s-bag.html