B328 hex file

[Phil]

Would someone put up a downloadable B328 hex file, please? Preferably mixing the two channels.

[earthwormjim]

Here is what I have been using...
http://www.pololu.com/docs/0J37/4
There is a link to download the hex file.
Has mixing.Works great.Uses PD0 and PC5 for ail & elev signal connection from rx.
Cheers Jim.

[Phil]

Thanks. I tried the 3kb hex file in the zipped download, but it didn't work for me. I am using a HK T6A V2 radio.

[earthwormjim]

Hi Phil.
Bummer.I have used it with spektrum,and the e-flyte ultra cheap tx,with no issues.
AFAIK,you can change the pulse widths to suit different recievers,but it is not something that I have ever needed to do.
But that could be the reason. Is it an HK rx,too? Can you find the pulse width??
"Standard RC receivers output high pulses between 0.5 ms and 2.5 ms"

Also,have you tested the baby-O works okay? Try the basic flashing led program first.
It is here,along with instructions...
http://www.pololu.com/docs/0J6/all#5
Let us know how you get on
Cheers Jim.

[peterwaller]

I have never used the B328 but the controllers I build have had problems with some receivers that output channels simultaneously rather than sequentially so if you have a scope it might be worth checking your particular receiver.

[Phil]

Thanks guys. The red led program worked for me. I don't have a scope.

[earthwormjim]

Are you using a cheap HK orange rx???
http://www.hobbyking.com/hobbyking/stor ... duct=11972
I use them with the baby-O,and have not had any probs.
Cheap too!

[Phil]

I use this Rx. I have used them before with a B328 programed by Steve Martin of BotBitz. It worked then. I can't get Atmel Studio 6 to work for me, so I am using kkMulticopterFlashTool to transfer the hex file to the board. I was just hoping someone might have a hex file I could try.