New antweight fighter

[Nixon]

Usually use it for prop replicas that don't need to have much structual strength so set it to about 25%. Printing the next chassis at 100% though, should be tough enough this time.

[Nixon]

Top printed off, just need to design a scoop/flipper thing.

[AntRoboteer]

Now that is impressive! Can't wait to see it at the AWS.

[Nixon]

The next few should be a lot fancier looking. Basically threw this togeather in a day so I'd have something for AWS.

[Remote-Controlled Dave]

Most of the robots that compete are thrown together in a day...

[Nixon]

Quickly bodged togeather a flipper thing. At least it's finished for Saturday.

[Remote-Controlled Dave]

Cool

[Rapidrory]

Does it fit in a 4 inch cube?

[Remote-Controlled Dave]

With the lifter up I'm guessing?

[EpicentrE]

I remember with the original version of Void, it only fit in the cube with the lifter all the way up. However. I couldn't adjust travel on my transmitter, so I had to turn the transmitter off, move the servo to the top of it's travel, and then only turn the transmitter on when the fight started and hope I got control before the opponent reached me!

(Re-reading my writing on my old robot pages makes me embarrassed. Please kindly ignore the "hehe", as well as any spelling or grammatical errors)