RobotWars101

Now i do like these bots, nice engineering/soldering and mechanical stuffs not just 3d printed and plastic

I love these, remind me of my heavyweight bots days by looking at thise pics...

must get printing my new bot haha

Well done

Hi Rory, thanks for getting back, do you know what it could be the cause, if it's the drivers themselves or the negative wire just touching the positive side of the capacitor in between as the heat causes the wire sheath to creep? I'd like to get it repaired so I can use it again, will check the spe...

So... I got my stuff out again to build a new antweight, not that I have yet competed with anything, nor built a bot worthy of the arena! But I plugged in my N2LVHP board to a 2s 350mah zippy lipo and smoke started to appear... I strip the heat shrink back to see if there is damage and although I ca...

I dont think it did, but if it didnt just file off the tab, fits perfectly.

Edit:

Although, if its for an ant, you may as well cut it off and solder directly to save some weight!

I have one of these, and they are 3 pin connectors on the other socket side, just one pin is not connected. Normally if they are the 2 pin battery connections, these sockets are red.

I have some nine eagles lipo s and battery sockets which I used on some test bots and on DELLApidated bANTry I have 2 single cell 260mah batteries from hobbyking in series cost 55p each. The socket was the costly bit, but handy to fit in the batteries into tight places.

Payment sent and options emailed. Been looking at adding my dealt and rx on them, or my 3 channel rx,.

I know there was mention of issues with the deltang rx with these but it was said it was the rx at fault? Page 7 of this topic

Thanks

Nat

Those look good, 3 dollars per motor, I must admit my cheaper eBay motors have had some failures, and mine haven't been in a fight yet...

Be interesting how they price the package with regards to importing...

Just took a look, and the N2LVHP seem the best options for me, could I place an order for 2 of these please, my email address is npoate @ hotmail.com if you could send PayPal details I can get that sent to you today! Postage will be to Bristol, bs32 4rt so £52 I believe? Thank you

Hiya,

Could i put in an order for one of the N2HV controllers?
If there is enough available for demand could i buy 2, my GF would like to have a go at building one