RobotWars101

I did this and it was easy, although i remember a couple of the wires being quite tight after moving things around. To do it, I removed the wires from the throttle cut button and soldered them to a button, removed the old throttle cut button then moved the Gear/F mode switch into the throttle cut ho...

Try this...Its a bit old but I've used it since I started in robots

https://youtu.be/6Ewa79_9Iq4

Sorry for the noob question but what size are the threads on the N20 gearbox's front plate?

I'm keen to get my bots on the list. Is there an ETA on when the registration page will be working?

Are you able to reflash escs? I'm sketching something up which may require rather compact packaging.

Just wondering, has anybody tried the DasMikro 5ch receiver with a nanotwo ESC?

Did anybody try this on 3s?

Its just a 180mah 2s lipo from hobbyking, nothing special. TGY-306G servo in there too which I'm pretty pleased with. I reckon I'll go with the 2mm polycarb. Again it's easily repeatable and dirt cheap to replace if one gets damaged. Quite intrigued to see how the cardboard and CA glue 'composite' a...

Hey, So it's taken over a year to get my second AW to the state it's in below and I'm a little stuck on how to create the flipper arm which would hinge on the vertical holes at the back of the chassis. Obvious options are to 3d print something, cut and glue components out of the GRP panel that the c...

It is just preformed sheets so I'll use normal super glue. Thanks for the response.

Dan