Stacking components?

All things antweight

Moderators: petec, administrator, BeligerAnt

Post Reply
Posts: 7
Joined: Tue Aug 21, 2018 11:26 am

Stacking components?

Post by mackemforever » Fri Oct 12, 2018 6:04 pm

Right now I'm in the process of putting together a beater spinner. I've tested everything, wired it all up, all of the electrics work absolutely fine. Now all that's left is to build the body for it.

The problem I'm having with designing the body is that I don't have a lot of weight to work with, and making it big enough for everything without it being so thin it's weak is proving tricky.

My question then is pretty simple, is there any problem with stacking various components? If I could stack the drive & weapon ESC on top of one another that would help the issue greatly. Provided both were properly insulated (most likely going to use a bit of heat shrink tubing), would this cause any issues?

User avatar
Posts: 224
Joined: Sun Aug 28, 2016 9:53 pm
Location: Bath, Somerset

Re: Stacking components?

Post by GeorgeR » Fri Oct 12, 2018 6:24 pm

Stacking is not a problem at all, as long as they are electrically insulated. The electronics on both my spinners are so tightly packed it can be hard to jam on the top of the robot!
Team Zero
Zero - rambot - - Axiom - axebot - - Valkyrie - drum spinner
Vampire - horizontal spinner - - RBMK - quad spinner gyro walker

Posts: 37
Joined: Sun Jul 01, 2018 6:18 am

Re: Stacking components?

Post by Matt » Sat Oct 13, 2018 7:12 am

Make sure it is all properly insulated, or you risk a short circuit. if you are using a separate receiver and controller, then trim the antenna as this can result in a short circuit. With my spinner I have to fit the battery in between the receiver and speed controller, and tape them back to stop them hitting the motor. But staking components should be fine if it is all insulated enough. Enough current can melt heat shrink so even if you have put heat shrink on, take care and check before every fight.

Post Reply