WANTED

Andrew_Hibberd · Post by **Andrew_Hibberd** » Sun Feb 26, 2006 10:08 pm

generic title

I am looking for some small metal gears, about 6mm long but quite small and light. They are to go into the gearing mechanism for the new ICant, new name to come. Just haven't much luck.

I have tried

RS
RobotCombat
Greenweld
ebay

Any help will be much appricated

Rhys · Post by **Rhys** » Mon Feb 27, 2006 12:31 am

Have you tried HPC gears? I used to have one of their catalogues. I know the go quite small, but i'm not sure how small.

olivers · Post by **olivers** » Mon Feb 27, 2006 8:12 am

http://www.muffettgears.co.uk/spur-gear.html

This is where I got small gears from in the past.

Andrew_Hibberd · Post by **Andrew_Hibberd** » Mon Feb 27, 2006 8:22 am

HPC seem to go down to mod1 for steel, which is 10mm wide teeth section.

Oliver they look good, will investigate later tonight when i get back in.

tom of technology · Post by **tom of technology** » Fri Mar 31, 2006 7:26 pm

please help me

i need 2 servo motor boards with k(sorry l)eads and plugs but not with gearboxhousing and motors

loo king ata a fver each
if anyones got one please pm me

8)

olivers · Post by **olivers** » Mon Apr 03, 2006 11:49 am

Tom, where do you live and what size of boards are you looking for. Micro servo boards or standard size?

tom of technology · Post by **tom of technology** » Wed Apr 19, 2006 6:09 pm

[quote="olivers"]Tom, where do you live and what size of boards are you looking for. Micro servo boards or standard size?[/quote]

i live ion susssex and anything (but standard would be good )im desperate

Andrew_Hibberd · Post by **Andrew_Hibberd** » Thu Jun 29, 2006 5:44 pm

Just using this thread again for wanted parts

I am looking for a ninco stinger, people must have them lying arround from the brushed spinner days.

It is going to replace the cheap nasty motor in anticide.

josh · Post by **josh** » Fri Jun 30, 2006 6:27 am

andrew i have a ninco nc5 motor -which is a newer version of the stinger- which im not usin if u want it

Andrew_Hibberd · Post by **Andrew_Hibberd** » Fri Jun 30, 2006 1:12 pm

Sounds good, could you put dimentions on a diagram and what is the weight?

Thanks, will talk on msn.