Hi All,
Does anyone have any experience in setting up a devo 7e (with Deviation 5.0 firmware) and a NanoTwo. I'm following all the steps I should be (I think), but I cannot get a successful bind.
1. All devices off.
2. Connect bind plug to two bind pins on the front of the NanoTwo
3. Connect battery to NanoTwo, light flashes rapidly.
4. Power UP TX
5. ENT -> Model Menu -> Model Setup
6. Load - Blank Model
7. Model Name: Model3
8. Icon: Default
9. Model Type: Plane
10. PPM In: None
11 .DSM2
12 .Fixed ID: 123456
13 .Channels: 4 (really not sure on this one|)
14. Hit Bind. Light goes off on nano two, then flashes slow, then just goes off.
15. The devo 7 doesn't get passed the binding model dialogue.
Any advice?
Devo 7e and NanoTwo
Moderators: BeligerAnt, petec, administrator
Re: Devo 7e and NanoTwo
And i've managed to fix it.....
Deleting the Fixed ID resolved the issue.
Deleting the Fixed ID resolved the issue.