Hi All
As some of you are aware I have ditched servos for the use of geared motors. However, these are also giving me issues. I have recently completed Baby Hell, and it seems that 1 motor runs fine in both directions, and 1 seems to only run in 1 direction. If anyone's got any bright ideas I'd love to hear them
thanks in advance
New Ants - problems
Moderators: BeligerAnt, petec, administrator
- peterwaller
- Posts: 3213
- Joined: Fri Feb 15, 2002 12:00 am
- Location: Aylesbury Bucks
- Contact:
You need to check if it is the motor or the controller. It is normally the controller in these situations although I recently had a motor that was jamming in one direction due to a bent set of brushes. Swap the motors and if the fault follows the motor its that if it stays with he controller then that is faulty.