Servo diagrams

Adam Hargreaves · Post by **Adam Hargreaves** » Wed Aug 31, 2005 6:55 pm

Hi. Has anybody got any burnt out micro servos that I could possibly buy/rent from them? I need the gearboxes for my DT project (I have motors from SD200s, so those would be prefferable).

Sorry, I don't usually like scrounging like this, but I'm skint atm!

As well as the above: does anybody know where I can get blueprints for any micro servo, and a standard servo (with dimensions on)

josh · Post by **josh** » Mon Nov 21, 2005 5:17 pm

adam ive got to [description deleted - mod] dead sd200's that u could ave if u cover p&p unles u already got some?

Post by **BeligerAnt** » Mon Nov 21, 2005 9:51 pm

Adam, I think you will struggle to find official dimensioned drawings of servos. The suppliers usually only give overall dimensions as lxwxh. Try trawling round the manufacturers web sites - you may find something.

I have resorted to drawing my own dimensioned drawings (from measurements!) for design purposes...

Dan · Post by **Dan** » Wed Apr 11, 2007 3:55 pm

hi guys does anyone know if there is such a thing as a screw/bolt small enough to fit throught the HS55 mounting plate holes?

cheers

Simon Windisch · Post by **Simon Windisch** » Wed Apr 11, 2007 4:57 pm

Can you measure the diameter Dan?

Simon

Dan · Post by **Dan** » Wed Apr 11, 2007 8:13 pm

yeah it looks like a 1.6mm would fit.
i just finished the polycarb chassis woo!

Simon Windisch · Post by **Simon Windisch** » Wed Apr 11, 2007 9:37 pm

If I were you I'd think about drilling them out to 2mm and getting M2 bolts.

Simon

Dan · Post by **Dan** » Fri Apr 13, 2007 10:02 am

ok thanks