Ant Attempt 2 - 'Tough Justice'

All things antweight

Moderators: BeligerAnt, petec, administrator

User avatar
GeorgeR
Posts: 280
Joined: Sun Aug 28, 2016 9:53 pm
Location: Bath, Somerset

Re: Ant Attempt 2 - 'Tough Justice'

Post by GeorgeR »

That black wire is one of the signal pads, it's connected to the bottom (in your pic) of R2, next to the first pad you lost. You should be able to see the track pretty clearly. This is the pad that I lost, and soldering on to that resistor is a challenge.
Be careful not to overheat the resistor as its easy to damage components that small. If you find the white wire in the middle of the board (between the red wires) is getting in the way you could remove it and attach it off board to the black wire coming from the battery, as they are connected.
Good luck!
Team Zero - AWS 58 Champion!
Zero - rambot - - Axiom - axebot - - Valkyrie - drum spinner
Blueprint - rambot - - Vampire - horizontal spinner - - Particle - ???
RBMK - quad spinner gyro walker - - Duality - dual spinner gyro walker
User avatar
peterwaller
Posts: 3213
Joined: Fri Feb 15, 2002 12:00 am
Location: Aylesbury Bucks
Contact:

Re: Ant Attempt 2 - 'Tough Justice'

Post by peterwaller »

Seeing as this seems to be a common problem here are some close ups of the board marked up with the pin designations and coloured lines showing alternative solder positions.
Image
Paulmchurd
Posts: 227
Joined: Sun Dec 10, 2017 4:39 pm

Re: Ant Attempt 2 - 'Tough Justice'

Post by Paulmchurd »

Worth a sticky!
User avatar
voorsk
Posts: 167
Joined: Tue Jan 02, 2018 8:11 am
Location: Stockport, UK
Contact:

Re: Ant Attempt 2 - 'Tough Justice'

Post by voorsk »

*saves image for future use* :D
Team BLEEP Suspicious Houmous / Sprouting Potato / Fermented Melon / Black Carrot
Post Reply