How did you go about attaching the flipper plate to the wire. Without 3D printed rings to fit through. I can't seem to find a decent hindge system.
I've glued paper clip ends onto the flipper panel which has worked so far. For battle though. I feel glue will not hold for long.
I was thinking maybe using this...
https://m.ebay.co.uk/itm/Dolls-House-Mi ... SwGwlaL5uG
Some questions about building an Antweight
Moderators: BeligerAnt, petec, administrator
-
- Posts: 227
- Joined: Sun Dec 10, 2017 4:39 pm
- peterwaller
- Posts: 3213
- Joined: Fri Feb 15, 2002 12:00 am
- Location: Aylesbury Bucks
- Contact:
Re: Some questions about building an Antweight
Brass is very heavy why not cut the flipper plate with two tabs on the side which you bend up and drill to fit the rod.
-
- Posts: 227
- Joined: Sun Dec 10, 2017 4:39 pm
Re: Some questions about building an Antweight
Ahhh smart idea.
Thanks
Thanks
-
- Posts: 22
- Joined: Sun Jan 07, 2018 11:13 am
Re: Some questions about building an Antweight
With regards to ordering the DasMikro, should I order option A, B or C. I'm guessing A as it has built-in tank style mixing and I think the robot drives like a tank.
-
- Posts: 227
- Joined: Sun Dec 10, 2017 4:39 pm
Re: Some questions about building an Antweight
Yes you want option A
-
- Posts: 22
- Joined: Sun Jan 07, 2018 11:13 am
Re: Some questions about building an Antweight
I have a robot with slanted sides, how would I attach that to the base at an angle. Also how do you post pictures, I could show you the cardboard model of my robot so you know what I mean.