Team MedBots
Moderators: BeligerAnt, petec, administrator
-
- Posts: 433
- Joined: Sun Nov 30, 2014 9:34 pm
- Location: Stroud,Gloucestershire
Re: Team MedBots
Although he's very busy Rory probably has a stock of them from China that aren't going to be too expensive
Team Badger
Has a 3d printer now yay
-£4.82+VAT (intact)
-cool modulated printed thingy
-not yet built nasty mean spinnt thingy
I'm gonna build something huge and stupid, try and stop me
Has a 3d printer now yay
-£4.82+VAT (intact)
-cool modulated printed thingy
-not yet built nasty mean spinnt thingy
I'm gonna build something huge and stupid, try and stop me
Re: Team MedBots
I sell them if you need some though I'm pretty busy with uni stuff so not sure if I can post quickly.
Nuts And Bots - For all your components and ready built antweights!
Alex Shakespeare - Team Shakey / Nuts And Bots / Team Nuts:
AWS 44, 45, 49, 51 & 55 Winner - Far too many robots!
Alex Shakespeare - Team Shakey / Nuts And Bots / Team Nuts:
AWS 44, 45, 49, 51 & 55 Winner - Far too many robots!
Re: Team MedBots
Anyone got some they could send on Monday/Tuesday?
-
- Posts: 441
- Joined: Mon Mar 03, 2014 7:01 pm
Re: Team MedBots
These are perfect if you need them in a hurry:
http://www.hobbyking.co.uk/hobbyking/st ... duct=89146
http://www.hobbyking.co.uk/hobbyking/st ... duct=89146
- peterwaller
- Posts: 3213
- Joined: Fri Feb 15, 2002 12:00 am
- Location: Aylesbury Bucks
- Contact:
Re: Team MedBots
Except they are out of stock.
Re: Team MedBots
They are out of stock because I bought the last 2!
-
- Posts: 37
- Joined: Sun Feb 14, 2016 10:16 am
Re: Team MedBots
Typical now dx6i has stopped working! Was working fine yesterday then went to turn it on and nothing, put in new batteries, nothing. I measured the voltage across the batteries it is 6v until I push the switch to the 'on' position then voltage drops to 0v! Measured the resistance between the terminals and it's about 1 mega ohm. Nothing obviously wrong on inside, any ideas?
Re: Team MedBots
possibly a dodgy solder joint somewhere inside the transmitter? i had to resolder a few joints in my orange TX to get it to work reliably. just a thought but it might be worth checking each solder joint.
other than that i can only say contact the supplier and report the fault you're experiencing with it.
good luck and i hope you get the issue sorted out.
other than that i can only say contact the supplier and report the fault you're experiencing with it.
good luck and i hope you get the issue sorted out.
Daniel Jackson.
Team Hectic.
Many antweights
Super antweights: territorial.
Fleaweights: fleadom fighter, gaztons.
Featherweights: hectic (under construction)
Team Hectic.
Many antweights
Super antweights: territorial.
Fleaweights: fleadom fighter, gaztons.
Featherweights: hectic (under construction)