team playzooki or whatever im gonna call it

[haz]

Its not *supposed* to be cut but you can remove it for antweight purposes. All my RX's are without aerials for one reason or another.

[AntRoboteer]

You could possibly the the case off of the receiver which in my case shed 7g. Could be more for your one as it is a bigger rx. Good luck getting it to run inverted!

[playzooki]

alright jaguar isnt working again this time its more serious as it doesnt seem to be recieving a signal, it just spin round in a circle. How do i fix it?

[AntRoboteer]

Have you tried re-binding the transmitter? That could be the problem. Also try changing the transmitter batteries as they might have run down.

The robot's battery should also be charged just in case that's the problem.

Hope that helps!

[Hogi]

what make of transmitter and reciever are you running?

[playzooki]

what make of transmitter and reciever are you running?

Both flysky.

Currently looking for batteries and bind plug

[playzooki]

Changing transmitter batteries didnt work, and the transmitter powers off after 30 seconds. I think there might be something wrong with the transmitter

EDIT
Good news! Jaguar lives!
Bad news! only for a minute at a time. I may have to switch the transmitter off and back on again halfway through matches. Or win quickly. Not likely with my driving style since i usually try to get to the sides of things

EDIT 2: transmitter as a mind of it own. Have to tilt it & stuff to get it to work. I think i may need a new transmitter.

[Hogi]

if it's the transmitter that's an issue it's not the end of the earth. although expensive brand new you can get some very decent bargains on ebay.

http://www.ebay.co.uk/itm/E-flight-Blad ... 3cf0921e98

that's the model I use and it's never failed me so far. if your reciever has DSM2 compatability then it'll just be a case of re binding it. if not, something like this will do the job: http://www.ebay.co.uk/itm/AR6100E-2-4GH ... _RadioCont

[playzooki]

ok so what happened is i asked for a chassis and the whole robot arrived :V
Problem is, I cant bind the reciever even with alex's instructions because i dont know how to solder :/

[Rapidrory]

You don't need to solder to bind the RX; just poke the bind wire through the bind holes in the RX (behind the throttle channel, labled 'Bi' in tiny writing) and turn it on.