Pop!
Moderators: BeligerAnt, petec, administrator
-
- Posts: 96
- Joined: Sat Oct 23, 2010 10:14 am
Re: Pop!
What gear ratio are the speed 900's running at?
Ben
The creator of... Laser, Evil Pig Sty and Striker
The creator of... Laser, Evil Pig Sty and Striker
Re: Pop!
4:1 on a 60mm dia wheel at 14.4v I think it was about 20pmh when I calculated it at no load.
RPD International
www.RPDintl.com
www.RPDintl.com
-
- Posts: 96
- Joined: Sat Oct 23, 2010 10:14 am
Re: Pop!
cool, Where are you getting your scorpian XXL from or is it 2nd hand?
Ben
The creator of... Laser, Evil Pig Sty and Striker
The creator of... Laser, Evil Pig Sty and Striker
Re: Pop!
straight from robot power, They sponsor my ants I need to speak to them about my feather but I'll probably end up buying it straight from them or on robotmarketplace.com
RPD International
www.RPDintl.com
www.RPDintl.com
-
- Posts: 96
- Joined: Sat Oct 23, 2010 10:14 am
Re: Pop!
I thought they are only doing the scorpian XL and re-designing the XXL
Ben
The creator of... Laser, Evil Pig Sty and Striker
The creator of... Laser, Evil Pig Sty and Striker
-
- Posts: 96
- Joined: Sat Oct 23, 2010 10:14 am
Re: Pop!
Cool, How much would it be and how many voltsand amps will it take max per channel?
Ben
The creator of... Laser, Evil Pig Sty and Striker
The creator of... Laser, Evil Pig Sty and Striker
Re: Pop!
http://www.robotmarketplace.com/product ... XL-V2.html
They seem to be available to buy there but Idn if they actually are.
20 amps continuous up to 28v
They seem to be available to buy there but Idn if they actually are.
20 amps continuous up to 28v
RPD International
www.RPDintl.com
www.RPDintl.com
-
- Posts: 96
- Joined: Sat Oct 23, 2010 10:14 am
Re: Pop!
Whats the flipper blade made from and what is the ground clearance at the back?
Ben
The creator of... Laser, Evil Pig Sty and Striker
The creator of... Laser, Evil Pig Sty and Striker
Re: Pop!
probably either titanium or hardox, I'll see how much weight I have when it's made. I might do all the density calculations later and see what it weighs. It's 7mm at the back but I'm working on a skirt that will be able to keep low but move over gaps and bumps.
RPD International
www.RPDintl.com
www.RPDintl.com